DIRECT POSITION DETERMINATION OF MULTIPLE RADIO SIGNALS
The most common methods for localization of radio signal emitters are based on measuring a specified parameter such as signal Angle-of-Arrival (AOA) or Time-of- Arrival (TOA). The measured parameters are then used to estimate the transmitter location. Since the measurements are done at each base station independently, without using the constraint that all AOA/TOA estimates must correspond to the same transmitter they are sub-optimal. Moreover, if the number of array elements at each base station is M the number of co-channel simultaneous transmitters that can be localized is M-1. We propose a technique that uses exactly the same data as the common AOA/TOA methods but the position determination is direct. The proposed method can handle LM-1 co-channel simultaneous signals, using L base stations. Although there are many stray parameters only two-dimensional search is required for a planar geometry and a three- dimensional search for the general case. The technique exploits the principles of the MUSIC algorithm, and provides a natural solution to the measurements-sources association problem that is encountered in AOA/TOA based systems.
Code (0)
등록된 구현이 없습니다.
Tasks
PositionSimilar Papers 제목 키워드 기반
Autonomous orbit determination for satelite formations using relative sensing: observability analysis and optimization
Orbit determination of spacecraft in orbit has been mostly dependent on either GNSS satellite signals or ground station telemetry. Both methods present their limitations, however: GNSS signals can only be used effectivel…
WiCAL: Accurate Wi-Fi-Based 3D Localization Enabled by Collaborative Antenna Arrays
Accurate 3D localization is essential for realizing advanced sensing functionalities in next-generation Wi-Fi communication systems. This study investigates the potential of multistatic localization in Wi-Fi networks thr…
One-Bit Direct Position Determination of Narrowband Gaussian Signals
One of the main drawbacks of the well-known Direct Position Determination (DPD) method is the requirement that raw signal data be transferred to a common processor. It would therefore be of high practical value if DPD$-$…
PositionQuantizationCross Correlation-based Direct Positioning for Wideband Sources using Phased Arrays
Recent developments in Phased Array direct positioning methods have improved accuracy for passively geo-locating multiple radio frequency-emitting signal sources. However, the number of geo-localisable signal sources is …
Harmonic and Interharmonic Detection in Power Systems Based on Fractal-Optimized Variational Mode Decomposition
The proposed method introduces a parameter determination approach based on the minimum Fractal box dimension (FBD) of Variational Mode Decomposition (VMD) components, aiming to address the issue of manual determination o…