Improvement of Frequency Source Phase Noise Reduction Design under Vibration Condition
Reasonable vibration reduction design is an important way to achieve low phase noise index of airborne frequency source output signal. Aiming at the problem of phase noise deterioration of an airborne frequency source under random condition, this paper proposes to improve the vibration reduction mode crystal oscillator and reduce the distance between the barycenter of frequency source and crystal oscillator vibration based on the analysis of the relationship between the frequency source and the phase noise of output signal. Experimental results show that the active noise control system achieves 62dB phase noise compensation under the random vibration of 0.04-0.1g*g/Hz amplitude range and 5-2000 Hz frequency range.
Code (0)
등록된 구현이 없습니다.
Similar Papers 제목 키워드 기반
Signal Processing Techniques to Reduce the Limit of Detection for Thin Film Biosensors
The ultimate detection limit of optical biosensors is often limited by various noise sources, including those introduced by the optical measurement setup. While sophisticated modifications to instrumentation may reduce n…
Phase Noise and Frequency Accuracy in Crystal-less Wireless Edge Nodes
This paper presents a fundamental analysis connecting phase noise and long-term frequency accuracy of oscillators and explores the possibilities and limitations in crystal-less frequency calibration for wireless edge nod…
Active Noise Control Portable Device Design
While our world is filled with its own natural sounds that we can't resist enjoying, it is also chock-full of other sounds that can be irritating, this is noise. Noise not only influences the working efficiency but also …
Online Expectation-Maximization Based Frequency and Phase Consensus in Distributed Phased Arrays
Distributed phased arrays are comprised of separate, smaller antenna systems that coordinate with each other to support coherent beamforming towards a destination. However, due to the frequency drift and phase jitter of …
Entropy-Based Doppler Centroid Estimation and Speckle Noise Reduction for Spaceborne SAR Imaging
In this paper, we present strip-map mode spaceborne Synthetic Aperture Radar (SAR) imaging with the focus on Doppler centroid frequency estimation. The non-zero Doppler centroid frequency is the result of non-zero squint…
Image Reconstruction